Gas Detection and Measurement

To maintain safety conditions during marine tanker operation, gas detection, and measurement is important for the vessel and its personnel safety.

The main requirements to check on the safety are as follows:

i.        Checking and maintaining safe levels of oxygen in enclosed spaces,

ii.        Monitoring oxygen levels in the inert gas and within the tanks,

iii.        Measurement of flammability of Hydrocarbon gas,

iv.        Measurement of Hydrocarbon gas prior to entering pump rooms and enclosed spaces,

v.        Location and Measurement of other toxic gases.

Instruments used

To be able to carry out this effectively there is a wide range of instruments that are fixed and portable for ship use. Each unit is usually calibrated for a specific gas and some have duel functions for example combustible gases and Oxygen.

It is important to know the instrument limitations as well as their function and method of use. Manufacturers hand books should always be consulted for full details regarding the instrument before use.

Instrument Calibration

To get accurate reading and maintain the reliability of gas detectors instruments it is important to have regular calibrating and testing. All instruments whether fixed or portable must be thoroughly checked before use and records kept of their checks and faults found.

To do the calibration correctly an adequate supply of calibrating gas must be available on board for the testing hydrocarbon equipment and pure nitrogen for checking oxygen analyzers.

Oxygen Analyzer

On ships that carry crude oil inert gas systems are essential to maintain safety, but the oxygen analyzer helps to detect and calculate that the oxygen levels remain below 8%. All ships must carry a portable oxygen analyzer to check oxygen levels within different places on the ship.

Limits of Flammability

Hydrocarbon flammability levels vary for different gases, but most petroleum product flammability ranges between 1-10% by volume also referred to as lower and upper flammability limits. Below the lower level the mixture is too weak to burn whereas above the limit it’s too rich to burn. Amount of oxygen available is also another limitation, with a minimum of 11.5% oxygen in air volume required to support combustion.

Catalytic Filament combustible gas indicator

Also referred to as an EXPLOSIMETER, is used for gas detection, and measurement below the lower flammable limit (LFL). The instrument measures on a scale of 0-100% LFL while some models have an additional meter that measure 1-10% LFL to allow for precise measurement of the lower ranges. These types of instruments can only read accurately in fresh air; and cannot be used with inert gases.

Non- Catalytic Heated Filament gas indicator

Tank scope an example of one type of these instruments is used to measure hydrocarbon on a scale of0-20% volume. It instrument works in all conditions as air is not a requirement for it to work therefore working in inert gas also.

It main purpose is to determine if hydrocarbons levels are below the Critical Dilution Line (CDL) thus avoiding to pass to the flammable zone when gas freeing is underway.

These are some of the instruments used for gas detection, and measurement of toxic levels on board marine tankers. Without these instruments modern shipping would have not advanced on safety levels that they have achieved. Today demand to transport hazardous material over long distances has made marine tankers the first choice as a transport mode.


VN:F [1.9.22_1171]
Was This Post Useful?
Rating: 6.4/10 (5 votes cast)
VN:F [1.9.22_1171]
Rating: 0 (from 2 votes)
Gas Detection and Measurement, 6.4 out of 10 based on 5 ratings

What Next?

Recent Articles